People Counter RAZL-2CO (Translation)
Step 2:
Connect slave pillar with
master pillar
In the menu
Select
device overview
Allow pairing
4.4 Determine type of use and mounting side of the sensor pillars
"
Installation of the counting light barrier...
" and "
Type of use
" must be set. Incoming and outgoing persons can only be detected correctly if the
setting corresponds to the actual installation location of the pillars and their use as an entrance and/or exit.
Step
1:
Device configuration of the
master pillar
Select
setting wheel
of the
master pillar
Configuring the master pillar
Step
2:
Wait until the slave pillar
appears in the device over-
view
If "
Active
" appears in the status bar, the slave pillar can be configured.
Step
3:
Device configuration of the
slave pillar
Select the
setting wheel
of the
slave pillar
Configure slave pillar
...
possibly configure further pil-
lars
... (like steps 2 and 3)
4.5 System configuration / pillar connection (master-slave)
Step 1:
Call up the menu (via menu symbol in the top left-hand corner), select
system configuration
Step 2:
Enter the maximum number of persons allowed and make further settings
Maximum permitted number
of persons must be set.
Step 3:
Save settings (via the
Save
field at the bottom)
Step 4:
Disable configuration mode again (log off via lock symbol)
-27-
Fiessler Elektronik GmbH & Co. KG
Phone: +49 (0)711 - 91 96 97 - 0
Internet: http://fiessler.de
Buchenteich 14, D-73773 Aichwald
Fax: +49 (0) 711 - 91 96 97 - 50
E-Mail: [email protected]
