Fieldmaster DOMINATOR GMF, Руководство владельца/оператора

Страница: 9 / 25

Page 9
Regular Checks
PROBLEM SOLVING
Mower Vibrates Excessively
a) Incorrect PTO speed: Check that 540 rpm PTO gear has been engaged. NOT 1000
rpm. Ensure that PTO does not exceed 600 rpm.
b) Blades missing or badly damaged: Fit replacement blades of the same type (ensure
that even sets are replaced).
c) Excessive driveshaft angles: Three-point linkage lifting too high. Limit the amount of
lift
d) Driveshaft universal joint badly worn: Inspect and repair as required.
Mower scalping severely: Raise the cutting height.
Oil or Grease on Drive decks
a) Gearbox output seal leaking: Consult your dealer about repair.
b) Gearbox over full: Gearbox casing should not be filled above oil level plug. Drain if
necessary.
c) Wing hinge pins over-greased: Clean off excess grease.
MAINTENANCE SCHEDULE BEFORE USE
/ EVERY 8
HOURS
FIRST 50
HOURS
EVERY 50
HOURS
EVERY 800
HOURS
a) BOLTS
Check fasteners for tightness

b) BLADES
Check condition and bolt tightness

c) DRIVESHAFT
Clean and re grease sliding tubes
Grease universal joints (2 points)
Grease guard bearings (2 points)
Oil quick release pins (2 points)
Check for excessive wear





e) GEARBOX
Check oil level – case should be half full
Change oil (1 litre EP90 oil)

 
f) WING HINGE PINS
Grease (4 points)

g) ROLLER BEARINGS
Grease (2 x points per roller)
