Fieldmann FZR 2046 E, Руководство пользователя, Страница: 13 / 20

EN 14
Troubleshooting
FZR 2046 E
8. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The handle is not in
the correct position The handle fi xing screws are not
correctly mounted.
The mower handle joining screws are
not tight. Adjust the height of the handle and make sure
the screws in the pre-bored holes are mounted
correctly.
Tighten the joining screws.
The mower does not
work.
The extension cable is not connected
to the mower socket.
The extension cable is not connected
to the electric socket.
The control trigger is defective.
Connect the cable again and use a cable
limiter to keep the cable near the trigger.
Connect the extension cable to a live socket.
Have the engine control trigger replaced by an
authorized service centre.
The mower cuts grass
unequally. The lawn is ragged or bumpy.
The mowing height is not set properly. Check the mowing area.
Move the fl oat to a higher position.
The mower does not
mulch properly. Wet grass is stuck on the bottom of
the plate. Wait until the grass is dry before mowing.
It is diffi cult to push
the mower. The grass is long or the mowing
height is too low. Increase the mowing height.
The mower vibrates at
high speeds. The engine shaft is bent.
The blade is not balanced.
Stop the engine, disconnect the mower
from the electricity and check that it is not
damaged. Repair the mower before starting it
again. If the vibrations continue, call the free
client line.
Balance the blade evenly by grinding each
cutting edge.