Fieldmann FZP 3714 B, Руководство пользователя

Страница: 11 / 25

EN 12
FZP 3714 B
Installing the bumper spikes, guide bar and chain
|
Fuel and chain lubricating oil
Put the sprocket cover back. Do not fully tighten the screws, tighten by hand only, to make it possible to
tension the chain.
Tension the chain using the tensioning screw (Fig. 5) and then tighten the sprocket cover nuts using the
included tubular wrench
ATTENTION!
The chain is correctly tensioned if it is possible to lift chain off the guide bar and its height in
the horizontal position in the middle of the guide bar is 3 to 4 mm.
6. FUEL AND CHAIN LUBRICATING OIL
Filling the oil tank
ATTENTION!
A new chain requires a certain running-in period, which is usually 5 minutes. The lubrication
of the chain is very important during this phase. After this running-in period, check the chain tension and
readjust if necessary.
The oil tank on the supplied chain saw is empty. Fill this oil tank with oil prior to fi rst use of this chain saw.
Only use oil specifi ed for total-loss lubrication
Screw off the oil tank cap (fi g. 6, point 1).
Pour the oil into the tank (take care to prevent the oil from becoming dirty while fi lling the tank).
Screw on the oil tank cap
ATTENTION!
Do not use oil that has already been used or processed because this could damage the oil
pump.
Mixing the fuel mix
ATTENTION!
Never pour fuel into the fuel tank in a closed and unventilated location.
ATTENTION!
Do not pour fuel in the vicinity of an open fl ame or a source of sparks.
ATTENTION!
Do not overfi ll the petrol tank. Before starting the engine, make sure that all spilt fuel is wiped
away.
ATTENTION!
If the engine is hot, DO NOT POUR IN FUEL.
For this type of two-stroke engine a mixture of lead-free petrol and two-stroke engine oil is used at a ratio of 25 : 1.
ATTENTION!
A fuel mix that is mixed at a ratio other than 25 : 1 may damage the engine. Make sure that
this fuel mix is mixed correctly.
When mixing petrol with two-stroke engine oil, use only petrol containing NO ETHANOL or METHANOL (types
of alcohols).
Use quality petrol with an octane number of 95 or higher. This will help prevent possible damage to the fuel
system and other parts of the engine.