Fieldmann FDW 2001-E, Руководство по эксплуатации, Страница: 19 / 23

FDW 2001 E
20 EN Troubleshooting guide
No water coming
out of nozzle Nozzle is clogged Clean the nozzle according to the instructions
provided in the Nozzle paragraph under
Maintenance section of this manual.
Water inlet filter
screen is clogged Remove filter screen (O) from the water inlet
(M) and clean it thoroughly. Replace the filter
screen.
Kink in the garden
hose or hose is
wrapped on a storage
wheel Use a maximum garden hose length of 50
ft. {15,2 m (city water) or 25 ft. (7.6 m) (well
water). Ensure the garden hose is laid flat and
does not have any kinks or leaks. Unwrap
garden hose from reel or hook (if applicable).
Replace garden hose if necessary.
Spray Gun Trigger
will NOT Move Gun safety lock is
engaged Release safety lock according to instructions
provided in the Starting paragraph under
Operation in this manual.
Unit will NOT start
Note:
Unit
will only start and
run when trigger
is depressed and
water is spraying!
Unit is not turned ON Verify that the ON/OFF switch is full ingaged in
the ON position.
Motor stops working
during normal
operation
Note: Motors
thermal overload
switch tripping
the motor is
overheated
Allow the motor
to cool for 20
minutes before
troubleshooting
and the switch will
automatically reset
Extension cord is too
long or wire- gauge is
too small We do not recommend using of extension
cords with your high-pressure washer. If you
must use an extension cord, verify that it
meets the minimum requirements listed in the
Extension Cord paragraph under the Power
Supply & Electrical info in this manual.
Defective Spray Gun Clean the nozzle according to the instructions
provided in the Nozzle paragraph under
Maintenance section of this manual.