Fieldmann FDS 10155-A, Руководство пользователя, Страница: 8 / 18

EN 8
Operation
FDS 10155-A
4. OPERATION
TO CHARGE
Make sure your screwdriver has completely stopped before attempting to charge it. Insert the power unit jack into
charging socket, making sure they are properly connected.
Power unit can be used with normal house voltage of 230V / 50 Hz, AC only.
1. After normal usage, the battery requires approximately 3-5 hours charging time to reach full capacity.
2. Connect the power unit to the power supply.
3. During the charge, the battery indicator (red light) will turn on.
4. After 3-5 hours charging time, pull out from power supply and start the screwdriver, if 3 battery indicator
lights are on, the screwdriver is full charged.
Do not place the power unit in an area of extreme heat or cold. It works best at normal room temperature. The
base of the tool or power unit may become warm during charging.
WARNING!
Only use the original power unit to charge the tool; use of other power units may cause
fi re, explosions, and serious injury.
Note: During the charge, the tool can’t be turned on.
WARNING!
Charging time must not exceed 15 hours; the battery may be damaged with excessive
charging. Avoid charging your screwdriver in freezing conditions. The power unit
provided must only be used with this screw¬driver and not with any other products.
Do not insert metal objects into the power unit.
Never change the forward/reverse switch while the screwdriver is rotating, as this will damage the screwdriver.
LED Battery Capacity Indicator
The battery capacity is indicated by 3 lights:
• Red LED is on - <20%
• Red & yellow LED’s are on - 20-70%
• Red & yellow& green 3 LED’s are on - >70%
Once only the red LED is lit, the screwdriver must be re-charged.
FITTING SCREWDRIVER BITS
Place a 1/4” bit into the magnetic bit holder and then insert the bit holder into the screwdriver collet.
Note: Your drill is intended for light-duty use. For best results, 1/4” screwdriver bits are recommended.
Never engage the trigger switch when changing screwdriver bits .
Always lock the trigger switch when changing drill bits. (See forward/reverse switch instructions.)