Fieldmann FDBP 200951-E, Руководство пользователя, Страница: 11 / 19

1 2
FDBP 200951-E BETL SANDER
EN Specific safety instructions | Use and operation
Kick-back is a sudden reaction on pinching or seizing of a rotating disk, support block,
brush or other accessory. Pinching or seizing causes sudden stoppage of a rotating tool,
which subsequently causes, that uncontrolled tool moves in the opposite direction to the
rotation of the tool in the moment of seizing.
Kick-back is a consequence of the use of electromechanical tools and/or incorrect working
procedures of conditions and it can be prevented by the compliance with the below
described safety measures.
The tool has to be held firmly while maintaining a correct position of the body and arms to
resist the forces of the kick-back. Auxiliary handle has to be used if the tool is fitted with it,
for maximum control of the kick-back or reaction torque when starting the tool. The
operator can control the reaction torques and the kick-back forces if the correct safety
measures are observed.
Do not put hands in the vicinity of the rotating tool. The kick-back of the tool may throw the
operators arm away.
Do not stand in the area, into which the tool might be thrown by the kick-back. Kick-back will
throw the tool in the opposite direction to the movement of the disk at the moment of
seizure.
Pay special attention to the machining of corners, sharp edges etc. Prevent skipping and
seizure of the tool. Corners, sharp edges or skipping tends to cause seizure of a rotating
tool and loss of control or kick-back.
Safety warning for works such as grinding, surfacing, wire brushing,
polishing or abrasive cutting
Follow the manufacturer's instructions while selecting the sand paper. Large sand
paper, which extends over the grinding disk, represents a risk of tearing and may
cause seizure, tearing of the disk or a kick-back.
6. USE AND OPERATION
This angle grinder is intended for household or hobby use only.
The manufacturer and importer do not recommend using this tool in extreme
conditions and
under high load.
Any other additional requirements must be agreed between the manufacturer
and the
customer.
Use the machine and attachments (note the manufacturer‘s specifications) only
for the
intended range of applications.
Any other use is strictly forbidden.
Additional safety instructions for surfacing
Safety warnings specific for surfacing: