Fieldmann FDB 2005-E, Инструкция по эксплуатации

Страница: 16 / 102

FDB 200 -E
Fig. 7
NOTE: Make sure the “good” side of the tile is facing upward to provide a smooth surface for the blade to
follow.
3. Place the tool with the saw blade (3) lightly touching the surface of the rile and the cutting teeth NOT touching
the surface to be cut.
4. Set the speed to the fastest speed and turn to tool ON (Fig. 5 & 6)
5. When the tool reach its maximum set speed, carefully plunge the blade into the door jamb while sliding the
blade along the floor tile..
NOTE: Hold the tool tightly and do not put too much forward pressure on the saw blade when cutting, as
this will cause the tool to vibrate excessively.
6. Continue to make several plunge cuts until the bottom of the door jamb and casing are completely cut off and
the loos pieces can be easily removed
Follow the same basic procedure for installing carpet, using a thicker spacer that is the same thickness of the
carpet being installed.
5.5 CUTTING A HOLE IN WOOD FLOORING TO INSTALL A HEATING VENT
The multi-tool can be used to cut a hole in wood flooring for installing a heating vent.
1. Install the plunge cutting saw blade for wood in the tool (Fig. 2)
NOTE: The blade should be centered on the tool housing and NOT installed in the 90°position.
2. Place the floor vent on the floor and use a soft lead pencil to trace the required rectangular hole (1) on the
flooring (Fig. 8).
Flush cutting a door jamb and casing for installing flooting |
Cutting a hole in wood flooring to install a heating vent
EN