Fieldmann 50005070, Руководство пользователя

Страница: 14 / 23

EN 14
FDMB 200170-A
4. USE AND OPERATION
The ASIST power tool is designed for domestic or hobby use only.
The manufacturer and the importer do not recommend to use this equipment under extreme conditions and at
high loads. Any other additional requirements must be agreed upon by the manufacturer and the buyer.
Charging the battery
1. Connect the charging cable connector with the charging socket of the device.
2. Plug the charger into an electrical outlet.
3. After the charging process, disconnect the charger from the mains supply.
Checking the battery charge level
If the appliance is switched on, the status/remaining charge will be shown on the battery LED as follows:
GREEN = maximum charge
ORANGE = medium charge
RED = low charge – charge the battery
Changing/inserting the tool/collet chuck
Press the spindle lock and hold it down.
Turn the tensioning nut until the lock clicks into place.
Undo the tensioning nut from the thread using the combination spanner.
Remove any tool which is inserted.
First push the intended tool through the tensioning nut before inserting it into the appropriate collet chuck for
the tool shaft.
Press the spindle lock and hold it down.
Push the collet chuck into the thread insert and screw the tensioning nut
Switching ON and OFF
1. Press the on/off switch to start the device.
2. To turn it off, release the on/off switch (5).
Switching on/setting the speed range:
Set the ON/OFF switch with the speed control to a position between „-a+“.
Notes on working with materials/ tools/speed range
■ Use the milling bits for working on steel and iron at maximum speed.
Determine the rotational speed range for working on zinc, zinc alloys, aluminium, copper and lead by trying it
out on test pieces.
Use a low rotational speed for work on plastics and materials with a low melting point.
Use a high rotational speed for working on wood.
Carry out cleaning, polishing and buffing work in the medium speed range. The following are
recommendations only and not binding. When carrying out practical work, carry out your own tests to see
which tool and which settings are ideal for the material you are working on.
Use and Operation