7
-
Ensure that the cardan shaft halves and protective tubes overlap as prescribed, both in
the transport position and in the working position. Read the operating instructions for the
cardan shaft in this context.
-
Always examine the power harrow for signs of damage following a collision with any
objects. Such damage must always be repaired before resuming work.
-
The cutter unit must never be operated when the rotary harrow is lifted off the ground.
-
When traveling round bends, take account of the larger width / length (turning circle) and
considerable weight of the power harrow.
-
Always wear tightly fitting clothes so that these cannot be caught between rotating parts of
the machine.
-
Safety stickers must be kept clean and observed!
-
Driving a tractor on steep slopes can be dangerous. If work on steep slopes is
unavoidable, great care should be exercised. Do not take bends too tightly.
-
Never crawl under a power harrow which is still connected to the tractor, as the machine
may be lowered at any time – high risk of injury.
-
Never open or remove the guard elements during operation. Worn or defective parts must
immediately be replaced by new parts.
-
Never climb or reach in between the support roller and cutter unit with your arms or legs-
high risk of injury.
-
No one may ever ride on the machine either during operations or while it is being
transported, not even over short distances.
-
Maintenance and repair work may only be carried out when the cardan shaft and machine
have been disengaged form the tractor.
-
Never allow anyone who is not familiar with the safety and operating instructions to use
the machine.
-
Adjust your driving speed in line with the ground conditions and prevailing circumstances.
-
No one may remain within 10 meters of the power harrow during operation of the machine.
High risk of injury due to moving machine parts and objects being hurled away from the
machine, such as stones, etc.
-
Never climb or reach in between the power harrow and the tractor with your arms or legs
during operation of the machine – high risk of injury! (This is only permitted when the
machine has been lowered to the ground and the tractor switched off.)
-
The machine should only be operated in full daylight. Traffic regulations must be observed
when driving on public roads. Adequate illumination must be ensured when driving in
twilight or darkness (A detachable set of lights is recommended.)
-
Never climb onto the tractor or leave it unattended when the p.t.o. shaft is running.
-
Remove all visible large objects which may be picked up and hurled aside by the power
harrow. Particular attention must be paid to loose wires on the ground.
8
Technical data and connections
-
The cardan shaft should only be engaged and disengaged when the tractor engine is
switched off and the ignition key has been removed.
-
The power harrow may only be operated with the cardan shaft with friction clutch supplied
by FIELDKING. FIELDKING cannot accept any liability for damage or losses due to use of
a different cardan shaft.
Warning: Never reach under the protective cover with hands or
feet.
Warning: Beware of being trapped!
Warning: Read operating instructions before use.
Warning: Beware of danger!
Warning: Beware of flying objects!
Warning: Keep a safe distance!
1.7
2.1
2.6
1.2
1.45
Blades Thickness (mm)
Cutting Width (m)
Gear Box Overload Protection
Tractor Power (HP)
No. of Blades
No. of Rotor
FKRPH-7
FKRPH-9
FKRPH-11
FKRPH-5
FKRPH-6
DESCRIPTION
Single Speed (540 / 302)
PTO RPM / Rotor RPM
9
18
7
14
11
22
55~75
75~100
100~125
5
10
40~45
6
12
45~60
Shear Bolt
14
Weight (Kg. Approx.)
650
800
950
450
550