© National Instruments Corporation
2-1
AT-FBUS for Windows NT
Hardware Installation
and Configuration
2
Chapter
This chapter contains instructions on how to install and configure your
AT-FBUS board.
Warning:
Before you remove the board from the package, touch the antistatic
plastic package to a metal part of your system chassis to discharge
electrostatic energy, which can damage several components on your
AT-FBUS board.
Evaluate the Hardware Settings
Table 2-1 shows the default hardware settings for the AT-FBUS board.
Table 2-1. Hardware Default Settings
AT-FBUS Board Setting
Default
Memory Base Address (hex)
D0000 (physical)
Interrupt Line (IRQ)
11
The AT-FBUS board default settings are suitable for most
PC AT-compatible computer systems. However, if these default settings
conflict with another device in your system, or if you need to install more
than one AT-FBUS board, you must change the default settings before
you install the board.
To change the default settings of the AT-FBUS board, refer to the
Configure the Hardware (Optional) section of this chapter. If you do not
need to reconfigure the board, proceed to the next section, Install the
Hardware.
