Before operating your whole house fan, be sure to open windows and close fireplace dampers.
Refer to your whole house fan manual for more information regarding operating your fan.
Turn the Fan On
Adjust the Cool Set To (Comfort) Temperature
PRESS
and
HOLD
or to adjust the Set To Temperature.
When the Set To Temperature is lower than the indoor temperature, the fan
is On and running (ON blinking). When the Set To Temperature is above
the indoor temperature, the fan is not running (ON is not blinking).
PRESS
to display ON. The fan will run (On blinking) when
the Set To Temperature is below the Indoor Temperature.
ON/OFF
The WTT wall control controls the whole house fan using temperature or timer control. Temperature control optimizes your
comfort and energy savings by never overcooling your home and only running the fan when needed.
Temperature Control
The WTT defaults to Temperature Control.
Adjust the Safety Timer Hours
PRESS
and
HOLD
for 7 seconds until STimer is displayed.
PRESS
and
HOLD
or to adjust the safety timer hours from
1 to 12 hours.
MODE
Safety Features in Temperature Control
The WTT On/Off key has to be pressed to turn the fan On. In
addition, there is a built in safety timer that will automatically turn the
fan off after 8 hours in case the homeowner forgets.
Timer Control
Turn the Fan On
Adjusting the Timer Setting
PRESS
and
HOLD
or to adjust the current Timer Setting. Or,
to set your preferred Timer Setting, turn the fan Off and
PRESS
and
HOLD
. or to adjust the timer setting. This timer setting will be used
each time the fan is turned on.
PRESS
to turn the fan ON. The fan will run for the timer
interval displayed.
ON/OFF
Switch To Timer Control
PRESS
then
PRESS
to select Timer Control. To return to
Temperature Control, press then press .
MODE
HOMEOWNER SECTION
This manual is separated into two different sections: one for the Homeowner and one for the Installer.
The Homeowner section contains information on features and operation of the wall control.
Indoor Temperature
Set To Temperature
Fan Speed
H
OFF
Set
Cool
To
SPEED
Indoors
Fan Status On or Off
Timer
H
SPEED
Indoors
OFF
Indoor Temperature
Timer Interval
Fan Status On or Off
Adjusting the Fan Speed
PRESS then
PRESS
and
HOLD
to adjust the fan speed. Available fan speeds depends on the type of fan installed.
SPEED
Note: The WTT wall control is factory set for 2 speed operation out of box from factory. If you have a 3-speed fan but can only select High (H) or Low (L),
the number of fan speeds may not have been set properly. Refer to Step 5, Set The Number of Fan Speeds, in the installer section of this manual.
Homeowner can select
High (H) or Low (L).
MODE
page 2 of 4
P/N 780104502 2/20 Rev A
2-Speed Fan
Homeowner can select High (H),
Medium (M) or Low (L).
3-Speed Fan
Fan Speed
Homeowner can
select High (H) only.
1-Speed Fan
