page 5
WARNING:
Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness.
Never operate the UV-Aire
®
Air Purifying System out of the plenum
. Avoid touching the glass portion of the lamp with your hands.
Remove base unit and cover from box.
3.
Apply supplied “Duct Seal Kit” according to instructions included in kit.
4.
(See Figure 12)
Determine whether to use flat or angled bracket. (Refer to UV-Aire
5.
Configurations in Section III for aid in this decision)
Flat Bracket Installation
a.
i. Remove the two hex nuts and flat bracket from included
bagged hardware.
ii. Install the flat bracket and secure to the unit base with the hex nuts
provided. (See Figure 13)
Angled Bracket Installation
b.
NOTE:
For angled bracket mounting, refer to specifications outlined by
Diagrams A & B for mounting distances in the “Angled Lamp Mounting Bracket
Specifications” in section III.
i. Remove the two hex nuts and angled bracket from included
bagged hardware.
ii. Install the angled bracket and secure to the unit base with the hex
nuts provided. (See Figure 14)
NOTE:
Be sure to note location of lamp hole in bracket relative to unit base.
Mount the unit base to the duct using the four mounting screws provided. (See
6.
Figure 15)
Remove tag and alcohol from lamp. Wipe off lamp being sure not to
7.
touch lamp with bare hands. The oils in your hands may cause the lamp to
prematurely expire.
Insert lamp through hole until lamp cannot be inserted any further.
8.
(See Figure 16)
Swing swivel bracket over end of lamp. Hand-tighten the wing nut on stud.
9.
(See Figure 17) Be careful not to over tighten the wing nut. The porcelain at
the lamp base may crack when over tightened.
Plug ballast plug into end of lamp. (See Figure 18)
10.
Figure 16
Figure 18
Figure 17
Figure 15
Figure 14
Figure 12
Figure 13
