FIBRO 2480.00.91.40, Руководство по эксплуатации

Страница: 30 / 40

30/40
Operating instructions EtherCatWPM Gateway Fieldbus
Operation
6.3.4 (deactivated) USB communication with BT LE module
In the WPM Gateway, the same Bluetooth LE chip set is used as in the FIBRO
USB radio stick.
The FIBRO WPM USB radio stick works with a virtual serial interface and a corresponding drive.
The WPM Gateway USB interface works according to the same virtual serial interface principle.
The WPM configuration software installs its own USB drive suitable for the WPM Gateway.
The function of the WPM Gateway USB interface is analogous to the FIBRO radio stick and
works with the WPM configuration software with no restrictions, provided there is a suitable li-
cense file in the gateway.
Please observe the WPM configuration software operating instructions when using it.
No actions and no configurations are performed for the WPM Gateway using the USB interface.
As long as the WPM configuration software populates the radio interface, the WPM Gateway
does not function. The WPM Gateway does not monitor any tools.
NOTICE
USB interface uses a the BT LE radio chip
The WPM configuration software interrupts WPM.
Gateway function
 No tool monitoring.

No tool paired.
 No WPM sensor data on the fieldbus.
 PLC programme receives no valid WPM sensor data.
NOTICE
USB interface without licensing
USB BTLE interface without function.

No license file for WPM Gateway.

No communication with WPconfig.

Special function required.