Fibocom L860-GL-16, Руководство по оборудованию

Страница: 4 / 60

Reproduction forbidden without Fibocom Wireless Inc. written authorization - All Rights Reserved.
FIBOCOM L860-GL Series Hardware Guide Page 4 of 60
End Product Labeling
When the module is installed in the host device, the FCC/IC ID label must be visible through a window
on the final device or it must be visible when an access panel, door or cover is easily re-moved. If not, a
second label must be placed on the outside of the final device that contains the following text: “Contains
FCC ID:
ZMOL860GL16
”
“Contains IC:
21374-L860GL16
“
The FCC ID/IC ID can be used only when all FCC/IC compliance requirements are met.
Antenna Installation
(1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.
(3) Only antennas of the same type and with equal or less gains as shown below may be used with this
module. Other types of antennas and/or higher gain antennas may require additional authorization for
operation.
Antenna type
PIFA
Antenna type
PIFA
Bands Peak Gain
Bands Peak Gain
WCDMA B2 4
LTE B17 3
WCDMA B4 3
LTE B25 4
WCDMA B5 3
LTE B26 3
LTE B2 4
LTE B30 1
LTE B4 3
LTE B38 4
LTE B5 3
LTE B41 4
LTE B7 4
LTE B48 1
LTE B12 3
LTE B66 3
LTE B13 3
LTE B71 3
LTE B14 3
In the event that these conditions cannot be met (for example certain laptop configurations or co-location
with another transmitter), then the FCC/IC authorization is no longer considered valid and the FCC ID/IC
ID cannot be used on the final product. In these circumstances, the OEM integrator will be responsible
for re-evaluating the end product (including the transmitter) and obtaining a separate FCC/IC
authorization.
Manual Information to the End User
Fibocom
Confidential