Rev.E • 08/04/04
- 5 -
P/N 75-15046-PM
This fixture must be properly installed in accordance with the National Electrical Code and all applicable local
codes and ordinances by a certified or licensed Electrician. Failure to do so may result in serious injury to
occupants, installers, or cause property damage due to the resulting electrical hazards. Read and follow all
instructions.
Volts and Amp rating for J400C and J400AS are as follows, 120 Volts, 84 Watts max., 2.0 Amps
Control Options for Jazz models J400C.
NOTE:
Metal Halide is not dimmable!
A. Switch
Controlled.
1.
The J400C Jazz color light versions must be controlled with two switches. The J400C have a 4
th
wire for color
wheel control, to start and stop the color wheel.
2.
For J400AS Auto Sync installations (multiple lights synchronized to change color at the same time) use the
appropriate number of power switches. Each JAZZ light has a run current of 2.0 amps. Only one switch is
required for color wheel control. All color wheel control wires for Auto Sync units must be run to one switch.
B.
Jandy RS Controlled or comparable control system.
1.
The J400C Jazz color version requires two
NON -Dimming
relays. One relay for the lamp and
one relay for color wheel control.
2.
For J400AS JAZZ Auto Sync installations (multiple lights synchronized to change color at the
same time) use the appropriate number of power
NON-Dimming
power relays. Only one
NON-Dimming
relay is required for color wheel control. All color wheel control wires for
Auto Sync units are run to one common relay.
C.
Fiberstars RM-400 Wireless Remote Control
(Maximum 2 units per RM-400)
D.
SPECIAL NOTE FOR X-10 CONTROL
The
lowest
possible
signal that can make a module respond properly is 150mV. Please refer to
the X-10 installation manual. Contact X10PRO for troubleshooting operation.
J400AS Auto Sync Operation
A.
Before operating, make sure both the power and color wheel switches are in the off position. (If the color wheel
switch is on when the power switch is activated the JAZZ units will not sync.)
1.
Switch the power on. (It will take 2-3 minutes for the Metal Halide lamp to come to its full level of brightness.)
The Auto Sync units color wheels will rotate to their home position on White. This action takes about 15
seconds.
2.
Switch on the color wheels. The JAZZ AS units are now in sync.
3.
When shutting down the system always turn the color wheels off. This will allow the color wheels to reset to
their home position the next time the lights are turned on.