79-15217-00 REV. A
www.fiberstars.com
Page 2 of 7
CAREFULLY READ AND FOLLOW ALL SAFETY
INSTRUCTIONS IN THIS MANUAL AND ON THE LIGHT
AND ASSOCIATED EQUIPMENT.
HAZARDOUS VOLTAGE
Incorrectly installed equipment may fail, causing severe injury or property
damage.
Have a certified electrician perform all tests before operating equipment.
To prevent the risk of damage or injury, do not operate the light out of water for more then 15 minutes.
Allow the light to cool down before installing underwater.
ATTENTION
Fiberstars JAZZ Series Wet-Niche Lighting Fixtures for Swimming pools are now ETL Classified for use with the
following manufactures Wet-Niches for use in new Pool construction. PENTAIR, (American) model no. 79206700
(ABS), model no. 7821XXXX (S/S), 7823XXXX (S/S), model no. 620004 (ABS) HAYWARD, model no. SP0607U
(ABS, Vinyl) SP0600U (ABS, Concrete)
ETL Classification Report No. 3040481
Risk of electrical shock.
Before removing fixture from pool wall, ALWAYS TURN OFF THE
POWER at the breaker.
Install this light and light niche in accordance with Article 680 of the National Electrical Code (NEC), in
the United States.
Install an approved Ground Fault Circuit Interrupter in the electrical circuit for this light.
All devices in the system must be directly grounded to a positive electrical ground. All devices in the
system must meet all applicable code requirements for bonding.
Operating pool light at a reduced voltage will diminish the lighting of your pool during nighttime use.
Failure to provide adequate lighting may result in swimming and diving hazards which can cause severe
injury or death
