FIBARO HC3L-001, Руководство по эксплуатации

Страница: 21 / 63

21
reDIscoverIng Z-Wave DevIces
11: REDISCOVERING Z-WAVE DEVICES
Rediscovery – the process of reading the device’s capabilities after
altering them.
1. Open the Configuration Interface.
2. Go to
> Devices .
3. Click the device to expand it.
4. Go to
Device configuration tab.
5. Under Device reconfiguration click Reconfigure device .
6. If the device is battery powered, wake it up manually or wait for next
automatic wake up.
12: CONNECTING WITH EXISTING Z-WAVE
NETWORK
12.1: ADDING/REMOVING TO/FROM EXISTING Z-WAVE
NETWORK
This gateway can be added to an existing Z-Wave network only if no
Z-Wave devices are added to it.
1. Start adding/removing procedure on the primary controller (according
to its manual).
2. Go to > Z-Wave .
3. Under Start Learn Mode click Start
4. If you are prompted for the PIN, you will find it on the bottom of the
gateway and on the box.
12.2: COPYING NETWORK INFORMATION BETWEEN
CONTROLLERS
Copying network information (Replication) is the process of updating
network information from a primary controller to secondary controllers,
such as node list and routing information.
These steps are usually not required unless you have a multiple controller
network.
Copying information from this controller to the secondary
controller
1. Start adding procedure according to chapter “Adding using Inclusion
Mode” on page 13.
2. Start Learn Mode on the secondary controller (according to its
manual).