26
insert the sealant cartridge (A) into
the corresponding compressor
compartment (F) and press it
down hard until you feel the
locking mechanism click. Remove
the speed limit sticker (D) and
apply it in a clearly visible position
wear the gloves
remove the tyre valve cap and
screw the transparent sealant
hose (E) onto the valve. Make sure
that the ON-OFF button is in the
off position (OFF position)
31 F1A0742
insert the electrical connector (H)
fig. 31 into the 12 V power socket
on the vehicle and start the engine
operate the compressor by
pressing the ON/OFF button
(ON position) fig. 30. When
the pressure gauge (B) reads
the prescribed pressure (see
the “Wheels” paragraph in the
“Technical data” chapter in the
Owner Handbook), switch off the
compressor by pressing the ON-
OFF button again
disconnect the cartridge (A) from
the compressor, by pressing
the release button (G) lifting the
cartridge upwards
If the pressure gauge (B) fig. 30
reads a pressure lower than 3
bar 15 minutes after turning on
the compressor, switch off the
compressor, disconnect the sealant
hose (E) from the tyre valve and
remove the cartridge (A) from the
compressor.
Move the vehicle approximately 10
metres to distribute the sealant.
Stop safely, engage the parking
brake and top up the pressure to
the prescribed value using the black
inflation pipe (C) fig. 30. If the pressure
is still lower than 3 bar 15 minutes
after switching on, do not resume
driving but contact a Dealership. After
driving for about 8 km / 5 miles, stop
the vehicle in a safe and suitable area,
and engage the parking brake.
Take the compressor and top up the
pressure using the black inflation hose
(C).
If the pressure reading is higher
than 3 bar, restore the pressure and
drive with great care to the nearest
Dealership.
