Fiat 500L 2018, Руководство пользователя

Страница: 13 / 180

General Information
The following regulatory statement applies to all
radio frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s)
. Operation is subject to the
following two conditions:
1 . This device may not cause harmful interfer-
ence, and
2 . This device must accept any interference re-
ceived, including interference that may cause
undesired operation
.
NOTE:
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user’s authority to operate the equip-
ment
.
VEHICLE SECURITY ALARM
The vehicle security alarm monitors the vehicle
doors for unauthorized entry and the ignition
switch for unauthorized operation
.
While the
vehicle security alarm is armed, interior switches
for door locks and liftgate release are disabled
.
If
something triggers the alarm, the vehicle security
alarm will provide the following audible and visible
signals: the horn will pulse, the park lamps and/or
turn signals will flash, and the vehicle security light
on the instrument panel will flash
.
To Arm The System
1 . Remove the key from the ignition switch and
get out of the vehicle
.
2 . Lock the door using either the Central Lock/
Unlock switch or the Remote Keyless Entry
key fob and close all doors
.
3
.
The horn will sound and the vehicle security
light in the instrument cluster will switch on
for approximately three seconds
.
This shows
that the vehicle security alarm is arming .
During this period, if a door is opened, the
ignition switch is turned to ON/RUN, or the
power door locks are unlocked in any manner,
the vehicle security alarm will automatically
disarm
. After approximately three seconds, the
vehicle security light will flash
.
This shows that
the vehicle security alarm is fully armed .
The activation of the vehicle security alarm is
followed by a self-diagnosis stage
.
If a fault is
detected during the self-diagnosis stage, the horn
will sound a second time
.
If the horn sounds a second time, check that all
doors, hood and liftgate are closed correctly, then
rearm the system
.
If the vehicle security alarm sounds the horn a
second time even when all doors, hood and
liftgate are correctly closed, a fault has occurred in
the operation of the system
. Contact your au-
thorized dealer
.
To Disarm The System
Push unlock on the key fob, or insert the key into
the ignition switch and turn the ignition switch to
the ON/RUN position
.
NOTE:
The vehicle security alarm will not disarm when
the metal insert of the key is used on a single
door lock cylinder
.
11