MAT2_
Data: 15/01/18
file: MAT2_ing.doc
Rev:2
pag 5/7
Magnetic band
The band consists of a magnetized plastic ferrite strip with alternate magnetic poles, carried by a
ferromagnetic steel strip. Mechanical protection of the plastic ferrite strip is supplied by a non magnetic steel
strip with tickness 0,2mm.
The magnetic band is assembled by sticking it with a biadhesive tape. The surface has to be smooth, clean
and dry: is advisable to clean it with a degreasing product (isopropyl alcohol, ethyl alcohol, solvents, etc). The
magnetic band has to be sticked holding the plastic ferrite side in the direction of the sensor, which means
the steel side leaned on the stand surface. Fixed the magnetic band, to keep off damages due to abrasions
or grazes of the plasic ferrite strip, is advisable the appliance (always biadhesive) of the non magnetic
protection streep.
The optimal ambient temperature for stick the biadhesive tape is over 10°C. The maximum adherence of the
tape works out after 48 hours (about) of the application and is kept between –10 and 80°C.
Electrical wiring
Brown
+24Vdc
Positive power supply
Green
GND
Negative power supply
Yellow
CK+
Clock+ SSI
Orange
CK-
Clock – SSI
White
D+
Data+ SSI
Purple
D-
Data - SSI
Grey
ZR
Zero input (PNP)
Black
DIR
Direction input (PNP)
