Fhiaba FP18FZC-LS1, Руководство по установке

Страница: 37 / 144

www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222) www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
37
EN
5.11 Mounting panels to the door
Once all brackets and small brackets
have been applied to the panels, you can
begin installing the bottom drawer.
> Hook the panel to the fixing devices starting
from the top aligning brackets [ 6 ] .
> At this point, alignment between the panel
and adjacent cabinets can be adjusted using the
alignment brackets and small brackets
[ 7 ] and
[ 8 ] .
> Vertical alignment: tighten or loosen the screw
in the brackets to raise or lower the panel
[ 9 ]
.
> Depth alignment: working from the inside of
the door, after lifting up the magnetic seal on the
handle side and rotating the plastic covers on
the hinge side, adjust the panel position in the
Z-direction by adjusting the shoulder bolts and
setscrews with the 4mm hex key in conjunction
with each other finally locking each mounting
position in place
[ 10 & 11 ] .
Once the front panel has been adjusted,
check that the gasket has been repositioned
correctly to assure the door/drawer are
closing correctly and avoid operational
errors of the unit.
The product handle is not included in the appliace
packaging, but it has to be bought separately.
For handle installation, please refer to the
instruction included in handle’s package.
5.12 Mounting panels to the drawer
Once all brackets and handles have been
applied to the panels, you can begin in-
stalling the bottom drawer.
Operate as follows:
> Partially tighten the screw to the receiver [ 1 ] .
7
8
6
10
11
9
1