FGM MM62DSGRD, Руководство оператора

Страница: 20 / 36

19
OPERATION
2) Lift the mower with the lift control lever of the tractor.
3) Stop the engine.
4) Adjust the front gauge wheel, rear gauge wheel and anti-scalp roller to obtain the desired cutting height.
Refer to page 22 "CUTTING HEIGHTS" for the cutting height adjustment.
5) Lower the mower with the lift control lever on the tractor.
6) Check to see that all the gauge wheels touch the ground. If not, adjust the front link length. When
adjusted correctly, the pin fixing the mower deck and front link can be easily pulled out.
7) Start the engine an lift the mower with the lift control lever of the tractor to the highest position.
8) Stop the engine.
9) Adjust the lift rod length so that the gap between the plate on the mower deck side and the stopper on
the tractor side is about 5mm. (STM60D-318/324 only.)
Figure 20
CUTTING HEIGHTS
This Mower can be adjusted to cut from 25 mm to 102 mm high. Cutting heights should be determined by cutting
conditions and personal preference.
The following recommendations will provide a guide for height selection.
Lawns 50 – 70 mm
Field cutting 60 – 100 mm
To change from one cutting height to another, it is necessary to adjust the gauge wheels and Anti-scalp roller.