ffelectronics Sidus F1C, Руководство по эксплуатации

Страница: 7 / 11

Sidus - electronic timer
7/11
JUMP2 JUMP2 JUMP2 JUMP2
Exit Exit Exit Exit Servo Servo Servo Servo
SET menu
Remote dethermalization (RDT)
The model can be dethermalized by keeping T3 (RDT) pressed until the display shows the
following message:
The Timer will terminate the sequence by executing the remaining steps until the disc
reaches the end of its travel.
Note: it is possible to program RDT to just stop the engine at first activation. Please
see the following for the details.
Advanced settings
From the MAIN menu enter the SET menu by pressing T4 (SET) for over 3 seconds:
Disc positioning modification
The Programmer allows changing the positions assumed by the disc for each function.
1. Press and release T4 (Servo) to enter the FUNCTION menu. The disc moves to the
start position
2. Press T3 (func+) or T4 (func-) to increase or decrease the current function and step
the disc to the related position. The disc steps to 7 different positions (START
→
FUNC1
→
FUNC2
→
FUNC3
→
FUNC4
→
FUNC5
→
DT). By convention, START
and DT correspond to the initial and final disc position respectively.
3. By T3 or T4 reach the wished function (e.g. FUNC5), then press T1 until the
POSITION menu is displayed:
START
START START
START f
ff
func+
unc+ unc+
unc+
Exit
Exit Exit
Exit f
ff
func
unc unc
unc-
--
-
FUNCTION menu
READ READ READ READ RDT RDT RDT RDT
WRITE WRITE WRITE WRITE SET SET SET SET
MAIN menu
RDT RDT RDT RDT
Transmitting Transmitting Transmitting Transmitting
…