Festool TS 55 FEBQ, Оригинальное руководство пользователя

Страница: 22 / 146

bles you to optimise the cutting speed to suit
each surface.
Speed range per material
Solid wood (hard, soft)
6
Chipboard and hardboard 3–6
Laminated wood, blockboard, veneered
and laminated panels
6
Laminate, mineral materials 4–6
Plaster- and cement-bonded chipboard
and fibreboard
1–3
Aluminium panels and profiles up to
15 mm
4–6
Plastics, fibre-reinforced plastics, paper
and fabric
3–5
Acrylic glass 4–5
Current limiting
Current limiting prevents excessive current
consumption under extreme overload, which
can lead to a decrease in the motor speed. The
motor immediately restarts after the load is re­
moved.
Brake
The saw TS 55 FEBQ comes with an electronic
brake. The saw blade is stopped electronically
within approximately two seconds of switching
off the machine.
Temperature cut-out
The power supply is restricted and the speed
reduced if the motor exceeds a certain temper­
ature. The power tool continues operating at re­
duced power to allow the ventilator to cool the
motor quickly. The power tool starts up again
automatically once the motor has cooled suffi­
ciently.
7.2
Adjusting the cutting depth
The cutting depth can be set at 0 – 55 mm at the
cutting depth stop [3-1].
The saw unit can now be pushed downwards as
far as the cutting depth that is set.
Cutting depth without guide rail
max. 55 mm
+FS
Cutting depth with FS guide rail
max. 51 mm
7.3 Setting the cutting angle
between 0° and 45°:
► Unscrew the rotary knobs [4-1].
► Swivel the saw unit to the desired cutting
angle [4-2].
► Tighten the rotary knobs [4-1].
Both positions (0° and 45°) are set at the
factory and can be readjusted by the cus­
tomer service team.
When making angled cuts, slide the view­
ing window/splinter guard to the highest
position.
To undercut -1° and 47°:
► Swivel the saw unit to the end position (0°/
45°) as described above.
► Pull out the release button [4-3] slightly.
► For -1° undercuts, also pull the release
button [4-4].
The saw unit engages in the -1°/47° position.
► Tighten the rotary knobs [4-1].
7.4
Selecting the saw blade
Festool saw blades are identified by a coloured
ring. The colour of the ring represents the ma­
terial for which the saw blade is suited.
Refer to the necessary saw blade data (see sec­
tion 3.1 ).
Colour Material Symbol
Yellow Wood
Red Laminate, mineral ma­
terial
HPL/TRESPA ®
Green Plaster- and cement-
bonded chipboard and
fibreboard
Blue Aluminium, plastic
"$3:-
7.5 Changing the saw blade
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
English
22