Festool RO 125 EQ, Руководство по эксплуатации

Страница: 4 / 7

7
Technical data RO 125 EQ
Power 500 W
Speed 3000 - 6000 rpm
Sanding stroke 3.6 mm
Weight (excluding cable)1.9 kg
Degree of protection / II
The specified illustrations can be found at the
beginning of the operating instructions.
1 Intended use
As specified, the machines are designed for
sanding and polishing wood, plastic, metal,
stone, composite materials, paint/varnish, filler
and similar materials.
Materials containing asbestos must not be
processed.
For reasons of electrical safety the machine
must not be damp nor operated in a humid
environment. The machine may only be used
for dry sanding.
The user is liable for damage and injury
resulting from incorrect usage!
2 Before starting up, please observe
the following
2.1 Safety instructions
Before using the machine, please read
the enclosed safety instructions.
- Harmful/toxic dusts can occur during your
work (e.g. lead-containing paint, some types
of wood and metal). Contact with these
dusts, especially inhaling them, can represent
a hazard for operating personnel or persons
in the vicinity. Comply with the safety
regulations that apply in your country.
Connect the electric power tool to a suitable
extraction system. To protect your health,
wear a P2 protective mask.
- Always wear protective goggles because of
possible dangers when sanding.
- The manufacturer’s handling and processing
instructions must be observed without fail if
explosive or self-igniting dusts are likely to
occur during sanding.
2.2 Noise and vibration information
The typical values determined in accordance
with EN 50144 are:
Measured acceleration 5 m/s²
Sound pressure level 81 dB(A)
Wear ear protection!
3 Power supply and start-up
The mains voltage must correspond to
the specification on the rating plate.
To switch on the machine, press the switch
(1.2) downwards and forwards until it locks
into place. To switch off, press the switch
downwards - this releases the switch locking
and it goes into the OFF position.
See Fig. 2 for connection and disconnection of
the power cable.
Always switch the machine off before
connecting or disconnecting the mains
lead!
4 Electronics
The machine has full-wave electronics
with the following features:
Smooth start-up
The smooth start-up ensures the router starts
up jolt-free.
Speed adjustment
You can regulate the speed steplessly between
3000 and 6000 rpm using the adjusting wheel
(1.6). This enables you to optimise the cutting
speed to suit the material.
Constant speed
The pre-selected speed remains constant
whether the machine is in operation or in neu-
tral position.
Temperature control
To prevent overheating, the safety electronics
switches the machine off when it reaches a
critical motor temperature. Let the machine
cool down for approx. 3-5 minutes before
using it again. The machine requires less time
to cool down if it is running, i.e. in neutral
position.
5 Machine settings
Always remove the power supply plug
from the socket before carrying out
any work on the machine.
5.1 Sanding motion
You can use the switch (1.1) to set two diffe-
rent sanding motions.
The change can only be made when
the sanding pad is stationary, as the
switch is locked in place during
operation for reasons of safety.
Seen at Ideal Tools.