Festool EHL 65 EQ, Оригинальное руководство пользователя

Страница: 14 / 76

CAUTION
Heating of the Plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
Always switch off the machine before
connecting and disconnecting the mains
power cable.
Connecting and detaching the mains power ca­
ble - see figure [2] .
To switch on: Press [1-7]
To switch off: Release [1-7]
7 Settings
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
7.1 Electronics
The machine features full-wave phase control
electronics with the following features:
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Constant speed
The motor speed remains constant through
electronic control to ensure a uniform cutting
speed even when under load.
Temperature cut-out
When exceeding a certain engine temperature
level, the machine power supply and speed are
capped. The power tool continues operating at
reduced power to allow the ventilator to cool
the motor rapidly. The power tool resumes to
full performance automatically once the motor
has cooled sufficiently.
7.2 Adjusting the planing thickness
► Use the rotary knob [1-4] .
increase plan­
ing depth
decrease plan­
ing depth
The marking [1-3] on the scale [1-5] around
the rotary knob indicates the planing depth set­
ting.
The space between two lines on the scale
represents a change in the planing depth
of approx. 0.1 mm .
Recommendation: do not set a planing thick­
ness greater than 2.5 mm for planing widths
over 40 mm.
7.3 Changing spiral blades [3]
WARNING
Worn spiral blades pose a risk of kickback
and could result in poor quality planing work
► Always use sharp, undamaged spiral
blades.
► Remove the Allen key.
► Loosen three clamping screws on the pla­
ner shaft.
CAUTION
Hot and sharp tools
Risk of injury
► Do not use insert tools that are blunt or de­
fective.
► Wear protective gloves.
► Remove the spiral blade.
► Clean the blade retaining groove.
► Insert spiral blade HW65 (488 503) with the
labelled side facing the rear planer foot.
► Align the spiral blade using a ruler so that
the face end is flush with the lateral edges
of the front and rear planer foot.
► Tighten the clamping screws (starting with
the central clamping screw).
If the planer blade protrudes slightly to­
wards either the inner or outer sides of the
planer head, this will lead to a distorted
cut width while rebating.
7.4 Dust extraction
WARNING
Heath hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
Dust extraction possible with:
– Chip collection bag [4-1] (accessory) on the
extractor connector [4-4]
– Mobile dust extractor with a suction
hose [4-2] with a dia. of 27 or dia. of 36 (ac­
cessory) on the angle adapter [4-3]
English
14