Festool C 12 Li, Инструкция по эксплуатации

Страница: 11 / 40

11
(e.g. round head or flat head screw with shank diam-
eter of 5 mm).
X
Insert the two screws into the wall at a distance of
96 mm from one another and leave the screw
heads protruding approx. 4 mm.
Settings
Consider the pictures on the fold-out page.
Changing the direction of rotation
The right/left switch [1-8] changes the direction of
rotation.
• Move switch from right to left = clockwise rotation
• Move switch from left to right = anticlockwise rota-
tion
Changing gear
L
Always switch off the machine before changing
gear!
You can change gear using the gear switch [1-4] .
• Switch forwards (Number 1 visible) = first gear
• Switch backwards (Number 2 visible) = second
gear
Fastening
Adjust the switch [1-7] so that its marking faces the
screw symbol [1-6] . The torque can be adjusted in
this position.
L
The switch-over function only works if the ma-
chine is switched off.
X
Adjust the torque accordingly at the torque wheel
[1-1] :
Position 1 = low torque
Position 25 = high torque
The machine switches off when the preset torque is
reached and an acoustic signal sounds. The machine
only continues running when the on/off switch
[1-9]
is released and then pressed again.
Drilling
Adjust the switch [1-7] so that its marking faces the
drilling symbol [1-5] . Maximum torque is set in this
position.
Tool holder, attachments
Tool chuck CENTROTEC WH-CE
The tool chuck CENTROTEC WH-CE allows you to
change tools with a CENTROTEC shank in a matter of
seconds.
L
Always use a CENTROTEC tool chuck to clamp
CENTROTEC tools.
Attaching the CENTROTEC
X
Pull the release ring [5-3] forwards.
X
Attach the tool chuck to the drill spindle [5-4] .
X Release the ring [5-3] .
4 mm/
0.16''
96 mm/
3.78 ''
WARNING
Risk of injury
X
Make sure that the machine is switched off and
the battery pack has been removed before
changing the tool holding fixure, attachments
and tools.
CAUTION
Risk of cutting injuries when changing the tool!
X
Wear protective gloves!