Festool 577069, Инструкция по эксплуатации

Страница: 14 / 51

Starting/stopping the cordless mobile dust
extractor manually
The cordless mobile dust extractor is in standby
mode.
Directly on the cordless mobile dust extractor:
► Press the MAN button [1-13] to start/stop.
Alternatively, use the connected remote control
CT-F I (see chapter 10.2 ):
► Press the MAN button [1-21] on the remote
control to start/stop.
Starting/stopping the cordless mobile dust ex­
tractor automatically
The cordless mobile dust extractor is in standby
mode.
► To start/stop the cordless mobile dust ex­
tractor automatically: Switch the connected
battery-powered power tool on/off (see
chapter 10.1 ).
10 Connecting a device
WARNING
Risk of injury from a cordless mobile dust
extractor starting up unsupervised
► Before performing any work with the cord­
less mobile dust extractor, check which re­
mote control and which cordless power
tool are connected to the cordless mobile
dust extractor.
► A battery-powered power tool must always
be connected to the cordless mobile dust
extractor via the suction hose. After finish­
ing work, the connection to the cordless
mobile dust extractor must be disconnect­
ed.
► The remote control must only be attached
to the suction hose.
10.1 Connecting a battery-powered power
tool
► In standby mode, press the connection but­
ton [1-16].
The connection display [1-17] slowly flashes
blue. For a period of 60 seconds, the cordless
mobile dust extractor is ready for connection.
► Switch on the power tool.
The cordless mobile dust extractor starts up.
The cordless mobile dust extractor is connect­
ed until the on/off button [1-12] is pressed or a
battery pack is removed (from the cordless mo­
bile dust extractor). The power tool must then
be connected again.
Connecting a new power tool overwrites
the previous connection.
This function is only possible on Festool
power tools with a Bluetooth
® battery
pack.
10.2 Connecting the CT-F I remote control
To be able to connect a remote control to a
cordless mobile dust extractor, the remote con­
trol must be reset (see "Reset on the remote
control").
Remote controls that have not been connected
previously can be connected directly.
A connection that has been created be­
tween remote controls and the cordless
mobile dust extractor will persist even af­
ter pressing the on/off button or removing
a battery pack (from the cordless mobile
dust extractor).
The cordless mobile dust extractor can be
connected to as many as five remote con­
trols at the same time. The cordless mo­
bile dust extractor can only be connected
to one battery-powered power tool at a
time.
If a cordless mobile dust extractor which
was initially switched on using the battery
pack is switched off using the remote con­
trol, the temporary connection between
the connected battery pack and the cord­
less mobile dust extractor will be lost. The
battery pack can then be connected again.
► Hold down the connection button [1-16] on
the cordless mobile dust extractor for three
seconds in standby mode.
The connection display [1-17] rapidly flashes
blue. For a period of 60 seconds, the cordless
mobile dust extractor is ready for connection.
► Press the MAN button [1-21] on the remote
control.
The remote control is permanently stored in the
cordless mobile dust extractor.
Resetting on the remote control
Resetting deletes the connection between a re­
mote control and the cordless mobile dust ex­
tractor.
► Press and hold the connection button [1-19]
and the MAN button [1-21] for 10 seconds.
The LED indicator [1-20] lights up purple, if the
reset has taken place.
English
14