Festool 575711, Оригинальное руководство по эксплуатации

Страница: 20 / 21

If the power tool is used in cordless
operation with a mobile dust extrac­
tor, the battery life decreases. Reduc­
ing the suction power minimises this
effect.
High suction power can impair control
of the power tool. Reducing the suc­
tion power minimises this effect.
Recommendation: Use an antistatic suction
hose. This helps reduce the electric charge.
7.5 Edge protector [6]
The edge protector [1-7] prevents the sanding
pad circumference from coming into contact
with a surface (e.g. when sanding along a wall
or a window), thus preventing back-kick of the
machine, or machine damage.
Push the edge protector into the groove on
the machine.
Slot the two ends of the edge protector into
place until they click.
Loosen both ends of the edge protector.
Remove the edge protector by pulling it for­
wards.
8 Working with the machine
WARNING
Risk of injury
► Always secure the workpiece in such a
manner that it cannot move while being
machined.
Observe the following instructions:
– Do not overload the machine by pressing
with excessive force! The best sanding re­
sults are achieved with moderate applica­
tion pressure. The sanding capacity and
quality are mainly dependent on the selec­
tion of the correct abrasive.
– Work in corners and on edges tends to sub­
ject the tip to increased stress and results
in increased heat development. In such ca­
ses, work with reduced contact pressure.
– Hold the machine with one hand on the
handle [1-8] .
8.1 Warning signal
The machine shuts down and makes a sound:
► Switch off the machine.
Battery pack is empty.
► Change the battery pack.
The machine shuts down and does not make a
sound:
Machine is overheated or has been overloaded.
► Switch off the machine for 30 seconds.
► Reduce the machine load.
If the machine's final speed is then not reached,
allow the machine to cool down.
9 Service and maintenance
WARNING
Risk of injury, electric shock
► When carrying out servicing and mainte­
nance work, always remove the batteries
or the mains adapter from the power tool
first.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs
must only be carried out by the
manufacturer or service work­
shops. Find the nearest address
at: www.festool.co.uk/service
Always use original Festool
spare parts. Order no. at:
www.festool.com/service
EKAT
1
2
3
5
4
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of any obstruction.
In the event of a slowdown in performance or
increased vibrations, blow and clean cooling air
openings.
► Keep the contacts on the machine, charger
and battery pack clean.
For service, maintenance, disposal and
transport of the battery pack, note en­
closed instructions of the battery pack!
10 Accessories
Use only original Festool sanding pads. Low-
quality sanding pads may cause serious ma­
chine imbalance that decreases the quality of
the working results and increases machine
wear.
English
20