Festool 575621, Инструкция по эксплуатации

Страница: 30 / 32

30
English
After finishing work
- After executing the non-through cuts, move the
riving knife [7-1] back into the upper position
and attach the guard [6-4a] .
Complicated concealed cut process
- e.g. plunge saws, resawing, dadoing, profile
routing and fluting are not permitted.
8.1d Featherboard
NOTE
Use a featherboard for non-through cuts. Fit the
featherboard on the fence and the table so that the
featherboard pushes the workpiece down firmly
onto the plate during cutting. Featherboards are
not included with the delivery.
8.1e Longitudinal cuts at an angle
- Only use the left fence when making longitudinal
cuts at an angle in material with an edge length
of ≤ 150 mm. This creates more space between
the fence and the saw blade.
8.2 Using the machine as a circular trim-
ming saw
8.2a Cross cuts
- Place the saw blade in the back table position,
see section 5.4 b).
- Use the preset profile setting rail as a crosswise
or angle ruler (fig. 3) to position the workpiece
and hold it in place. Fastening clamps (not
included in delivery) can be inserted into the
grooves
[3-8] to secure the workpiece. Carry
out the saw cut by swivelling the handle [3-9]
downwards and using it to pull the saw unit
forwards.
- After completing the cut, move the saw unit right
back to its starting position before removing the
workpiece from the preset profile setting rail.
8.2b Angled cuts
- The mitre angle of the saw blade needs to be
adjusted for angled cuts, see section 7.2. The
preset profile setting rail is on the right-hand
side of the table.
- For mitre cuts, the preset profile setting rail has
to be adjusted, see section 7.5.
8.3 Push stick
- When not in use, the push stick [2-4] should be
placed in the accessory holder [2-1] .
9 Service and maintenance
Always pull the mains plug before main-
taining, servicing or making any kind of
adjustment.
All maintenance and repair work which
requires the motor housing to be opened
must only be carried out by an authorised
service workshop.
Damaged safety devices and components
must be repaired or replaced in a recog-
nised specialist workshop in accordance
with regulations, unless otherwise indi-
cated in the operating manual.
Customer service and repairs: Only by
manufacturer or service workshops. Find
the nearest address at: www.festool.com/
service
EKAT
1
2
3
5
4
Always use original Festool spare parts.
Order no. at: www.festool.com/service
The machine is equipped with special self-dis-
connecting carbon brushes. If they wear out, the
power supply is disconnected automatically and
the tool stops.
Maintain your machine regularly to make sure it
functions properly:
- Use an extractor to remove dust deposits,
- Keep guide rods
[1-10] clean and grease them
regularly,
- Replace worn or damaged table inserts,
- Use the slide
[11-1] to open the flap [11-3] in
order to remove offcuts from the lower guard.
To remove larger deposits, the flap can be com-
pletely opened by unscrewing the screw
[11-2] .
Close the flap again prior to use.
- After completing work, wind up the power cable
onto the accessory holder [2-1] .
- A damper allows the saw unit to retract evenly
along the entire cutting length. If this is not the
case, the damper can be adjusted using the hole
[2-5] .
- If it becomes necessary to replace the power
cable, this must be carried out by the manufac-
turer or the service team in order to ensure that
no hazards arise.