Festool 204079, Оригинальное руководство пользователя

Страница: 23 / 26

5.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
function ensures that the power tool starts up
smoothly.
Speed regulator [1-4]
You can continuously adjust the speed within
the speed range using the adjusting wheel .
This enables you to optimise the speed to suit
the respective material. Please also note the
specifications on the sanding tools.
Constant speed
The preselected motor speed is kept constant
through electronic control. This ensures a uni­
form speed even when under load.
Recoil protection
In the event of a sudden speed reduction, e.g. if
the power tool becomes jammed in a separat­
ing cut, the motor is switched off immediately.
To put the power tool back into operation, it
must first be switched off and then on again.
Restart protection
The built-in restart protection prevents the
power tool from starting up again automatically
if the power is disconnected during continuous
use. To put the power tool back into operation,
it must first be switched off and then on again.
Overheating protection
In the event of overheating, the safety electron­
ics system switches to cooling mode. The motor
continues to run and the constant speed is de­
activated. Let the machine cool down for ap­
proximately 10–20 seconds before using it
and/or fully loading it again.
6 Commissioning
6.1 Holding the power tool correctly
Hold the power tool with both hands using the
insulated gripping surfaces [1-7]: One hand on
the motor housing behind the switch and the
other on the auxiliary handle [1-6].
6.2
Switch on/off
Switching on [2a]
► Push the on/off switch [1-5] forwards.
Pressing the front part of the switch at the
same time locks the on/off switch.
On/off switch [1-5] is locked and the power tool
is switched on.
Only position the tool on the material once
it has reached operating speed.
Setting the speed
The speed can be adapted in six settings de­
pending on the workpiece requirements.
► Set the speed regulator [1-4] to the re­
quired setting.
Switching off [2b]
► Lift the power tool from the processed ma­
terial.
► Press the rear part of the on/off
switch [1-5].
Lock is released and the power tool is switched
off.
WARNING
Risk of injury from kickback, ejected parts
► Before setting down the power tool, wait
until the rotating sanding tool has come to
a complete stop.
► Set the power tool down on the support
points [1-11].
7 Battery pack
► Inserting the battery pack [3a]
► Removing the battery pack [3b]
7.1
Capacity display
The capacity display [1-10] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-9] is pressed:
70‑100%
40‑70%
15‑40%
< 15% *
*
Recommendation: Charge the battery pack
before any further use.
Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
8 Settings
WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
English
23