Festool 10019662, Руководство по эксплуатации

Страница: 17 / 118

► Follow the instructions provided in the Fes­
tool app.
6.5 Remote control (MINI I / MIDI I)
Connecting the remote control and mobile
dust extractor
To be able to connect a remote control to a mo­
bile dust extractor, the remote control must be
reset (see "Resetting the remote control").
Remote controls that have not been connected
previously can be connected directly.
A connection that has been created
between remote controls and the mo­
bile dust extractor will persist even
after the mobile dust extractor has
been manually switched off or the
mains plug has been disconnected.
The mobile dust extractor can be con­
nected to as many as five remote con­
trols at the same time. The mobile
dust extractor can only be connected
to one cordless power tool at a time.
► Hold down the connection button [1-20] on
the mobile dust extractor for three seconds
in standby mode.
The connection display [1-19] flashes rapid­
ly.
For a period of 60 seconds, the mobile dust
extractor is ready for connection.
► Press the MAN button on the remote con­
trol.
The remote control is permanently stored in
the mobile dust extractor.
Switching on/off
Once the remote control is connected to the
mobile dust extractor, the mobile dust extractor
can be switched on and off with the remote con­
trol.
► Press the MAN button on the remote con­
trol to switch the device on and off.
Resetting the remote control
Resetting deletes the connection between a re­
mote control and the mobile dust extractor.
► Hold down the connection button and the
MAN button for 10 seconds.
The LED indicator lights up purple, if the re­
set has taken place.
6.6 Delete all saved devices. (MINI I / MIDI
I)
► Press and hold the connection button [1-20]
for at least three seconds.
The connection display [1-19] flashes rapid­
ly.
► Press and hold both the plus and minus
button [1-18] for at least three seconds.
The mobile dust extractor confirms the com­
mand by rapidly flashing three times.
7 Settings
7.1 Setting the suction hose diameter
The suction hose diameter is detected
automatically for suction hoses with
an RFID chip.
For suction hoses without an RFID chip, the
suction hose diameter must be set manually in
standby mode.
► Press the plus or minus button [1-18] until
the required diameter is set.
An LED lights up in the field with the re­
quired diameter.
If a suction hose with an RFID chip is
connected, the manual settings are
overwritten.
7.2 Adjusting the suction power
► Press the plus or minus button [1-18] while
extracting.
7.3 Volumetric flow monitoring
For safety reasons, an acoustic warning signal
sounds if the air speed in the suction hose falls
below 20 m/s (dust class M only).
Possible causes Solution
Suction power adjustment [1-18] not set to a
high enough value.
Set the suction power adjustment to a higher val­
ue (see chapter 7.2 ).
Suction hose adjustment [1-18] not set to the
diameter of the connected suction hose (only
for suction hoses without an RFID chip).
Set the correct suction hose diameter (see chap­
ter 7.1 ).
English
17