3. Remove the packaging in accordance with the printed sequence.
7
Assembly
CAUTION!
Risk of injury due to falling product.
•
Make sure the mounting surface is sufficiently strong to absorb the maximum forces.
•
Only use suitable mounting components.
•
Secure the screw connections.
Observe the information on mounting components in the applicable documentation
è
1. Assemble the cylinder DSBG and accessories as follows.
–
Assemble the DSBG backlash-free and free from transverse loads.
–
To prevent friction, ensure parallelism with the guide unit.
–
If possible, use a self-aligning rod coupler to balance the angular and radial backlash.
2. Mount the proximity switch SMT as a reference sensor to the displacement encoder DNCI. The
proximity switch is needed for homing the displacement encoder. Information on homing
è
–
Attach the proximity switch near the lower end position of the DNCI. Tightening torque:
£
0.6 Nm
3. Install the displacement encoder DNCI backlash-free and parallel to the cylinder DSBG.
–
There must be a secure connection between the DSBG piston rod and DNCI piston rod.
–
Choose suitable accessories in accordance with the installation situation.
4. Assemble the valve unit VPCB.
5. Connect the valve unit VPCB with the cylinder DSBG. There are two options for this:
–
Connect the valve unit VPCB directly with the cylinder DSBG using a double nipple.
Internal diameter:
³
8 mm
–
Connect the valve unit VPCB with a pipe or a suitable hydraulic hose
£
300 mm with the cylin-
der DSBG.
A connection with the aid of tubing is not permitted.
6. Assemble the control element VAOH in the appropriate place. Tightening torque:
£
10 Nm
Assembly
9
Festo — YHBP — 2020-09