Festo Smart cubic CPVSC1-VI, Руководство пользователя

Страница: 72 / 92

5. Maintenance and conversion
5−6
Festo P.BE−CPVSC−E N en 0301a
5.3 Fitting/removing components in valve locations
Please note
The double−solenoid valve (Ident. code J) consists of two
components, the control valve and the work valve. Each
sits in its own valve plate. The control valve is marked on
the front with j 12; it does not have any work connections
and is situated to the left of the work valve. The work valve
is marked with the Ident. code J.
Components in valve locations can be exchanged easily with
out much trouble.
Proceed as follows:
5.3.1 Preparing the CPV−SC valve terminal
1. Loosen the multipin plug and disconnect it carefully.
2. Loosen the tubing at work connections 2 and 4 of the
valve plate to be replaced (see section 3.2 General notes
on connecting").
3. Loosen the wall fastening on the right−hand end plate.
5.3.2 Remove the components
1. Unclamp the valve manifold. To do this, loosen the tie rod
screws one turn. Then unscrew the tie rod screws so that
the screw heads project up to 9 mm out of the end plate
(do not remove the tie rod screws).
2. Pull the valve terminal apart so that there is a gap of at
least 2 mm to the left and the right of the component to
be replaced.