Festo SFC-LAC CO Series, Руководство пользователя

Страница: 84 / 328

4. The control panel (only type SFC−LAC−...−H2−...)
4−14
Festo P.BE−SFC−LAC−CO−EN en 0708NH
4.5.1 [Settings] [Axis type]
[Axis type] Parameters
[HME−...] Electric linear module
Select the type used:
e.g. HME−16−100 for an HME of size 16 with
100 mm rated stroke.
4.5.2 [Settings] [Axis parameter]
Teach mode for setting the axis parameters
·
Note the instructions in section 5.2.6 and 5.2.7.
[Axis parameter] Description
[Zero point]
*)
Offset axis zero point
[SW−limit−neg]
*)
Software end position, negative
[SW−limit−pos]
*)
Software end position, positive
[Tool load] Tool mass, e.g. a gripper on the front panel of
the HME−...
[SAVE...] Save parameters in EEPROM
*)
Teaching only possible after successful homing.
Note
A new reference run must always be carried out if the axis
zero point is modified.
The project zero point PZ can only be set via FCT or
PNU500/CI21F4
h
.