Festo SDE1 Series, Руководство по эксплуатации

Страница: 48 / 64

SDE1−...
Festo SDE1−... 0511e English
48
Preparing for commissioning
The basic status is called the RUN mode. This shows the current measured value.
The RUN mode can be accessed from other modes:
By pressing the EDIT button for 3 seconds
If a monitoring time expires (timeout: see section 13, Menu structure)
S
Switch on the operating voltage. The SDE1−... is then in the RUN mode.
S
Check the functions of the SDE1−...
Please note
An overview of the menu structure can be found in section 13. Note that only
product versions P2, 2I and N2 are equipped with two switching outputs (Out A
and Out B). Other product versions have only one switching output (Out A).
RUN mode
Shows the measured value (relative pressure/differential pressure) and the signal
status of the switching outputs (Out A/B). A flashing value indicates that the
measuring range has been exceeded.
S
Pressurize the SDE1−... with different
pressures.
The number and bar display will change
accordingly.
Fig.15