2.3 Wall mounting with mounting bracket PAML-MB
Note
Always mount an individual device with two mounting brackets. Mount a service
unit with a mounting bracket at both the beginning and the end of the service
unit string and between the individual service units.
1. First mount all required wall brackets
aJ
with two M8 screws each at the required
positions. The standard grid width between the wall brackets is 90 mm, and the dis
tance in height between holes is 145 mm.
All retaining screws
aC
must point upwards.
Note
The grid width for the filter PFML-90 is 135 mm and deviates from the standard.
2. First, push both mounting screws through both holes of the front plate
aB
.
3. Place the seal between the service units.
4. Place the front and rear plate
aB
and
aA
into the slots of the service units.
5. Screw the mounting screws of the front plate
aB
into the rear plate
aA
.
6. Repeat steps 2 to 5 for all required mounting brackets.
7. Loosen the retaining screws
aC
.
8. Place the service unit combination with the lugs of the rear plates into the
elongated holes of the wall brackets
aJ
.
9. Tighten the retaining screws
aC
.
10 Nm
2 Nm
aJ
aA
aB
aC
Fig. 5
3
Dismantling
Warning
Risk of injury from compressed air.
Products under pressure can cause personal injury and material damage.
Depressurize service unit string and tubing.
Warning
Risk of injury from falling loads.
Take the weight of an individual device or a service unit into consideration.
Dependent on the design, a mounted service unit can weigh more than 50
kg.
Note
Dismantling only by qualified personnel.
If used as intended, the surface temperature can reach 60 °C. Allow the device
to cool off before any maintenance work.
Depressurize the pneumatic system.
Remove the existing service unit string.
4
Technical data
PAML
-MK
-MB
-CP
Operating pressure
[bar]
0 50
Operating medium
Compressed air according to ISO 8573-1:2010 [-:-:-]
Temperature of medium
[°C]
5 … 60
Ambient temperature
[°C]
5 … 60
Classification in accordance with
EC Pressure Equipment Directive
Category I
CE marking
According to EC Pressure Equipment Directive
1)
Declaration of Conformity
è
www.festo.com/sp
Fig. 6
