Festo MPA-L Series, Описание

Страница: 45 / 160

2. Mounting
2−5
Festo P.BE−MPAL−EN en 1008NH
Valve terminal variant Mounting points
1
MPA−L with multi−pin plug connection
1
Required mounting of the H−rail
clamping units:
In the right−hand end plate
and the multipin sub−base:
each with one M4 screw
1
and each with a clamping
component
1 1
MPA−L with CPX terminal
2
Required mounting of the H−rail
clamping units:
In the end plates:
each with one M4 screw
1
and each with a clamping
component
In the pneumatic interface:
one M6 screw
2
and a
clamping component
Tab.2/1: Mounting points for H−rail mounting
Mounting Proceed as follows:
1. Make sure that the mounting surface can support
the weight of the valve terminal MPA−L (weights see
appendix A, Tab.A/1).
2. Mount the H−rail (DIN mounting rail EN60715 − 35x7.5;
width 35mm, height 7.5mm). Make sure there is suffi
cient space for connecting the power supply cables and
tubing. Fasten the H−rail(see Fig.2/1) to the mounting
surface approximately every 100 mm.
3. Mount the H−rail clamping units at all required mounting
points (see Tab.2/1). Make sure that the clamping ele
ment (see Fig.2/1,
3
) lies horizontally to the H−rail.