Festo HSP AE Series, Руководство пользователя

Страница: 112 / 174

5. Commissioning with the control panel
5−20
Festo P.BE−HSP−AE−IO−EN en 0510NH
The specifications in angle degrees can be converted approxi
mately into linear paths with the aid of the following table.
Size y−direction
1° = ... z−direction
1° = ...
HSP−12−..−AE 0.4 ... 0.6 mm 0.45 ... 0.6 mm
HSP−16−..−AE 0.75 ... 1 mm 0.8 ... 1 mm
HSP−25−..−AE 1 ... 1.5 mm 1.1 ... 1.5 mm
Speed [Velocity] = speed of the positioning procedure.
The average speed amounts to 50 % of the set speed.
With the speed entry in °/s the achievable positioning time
for the relevant size can be set. In operation there is no sense
in setting the drive at the maximum permitted speed, as the
complete cycle time and the maximum vibration amplitude
increase extremely due to the subsequent oscillation.
Please note
For insert procedures the speed in the vertical linear range
must be reduced.
·
Use preferably torque switching for insert procedures.
With torque switching the speed is specified at the
factory.
Blocking positioning sets:
Positioning sets with the speed v = 0 are not processed.