Festo EXCM-40 -PF Series, Инструкция по эксплуатации

Страница: 19 / 48

4 Mounting
Festo – EXCM-40-EN – 2017-11a – English 19
8. Apply counter pressure to the adjusting
bolt
5
to maintain alignment.
9. Tighten the screw
7
(tightening torque
24 Nm).
10.Repeat the previous steps for all adjusting
kits.
5
7
Fig. 4.10
11.Inspect the guide rail of the X-axis 1 again for compliance with the limit values for evenness and
sideways tilting.
è
The X-axis 1 is aligned and now forms the basis for further alignment of the product.
4.4.3 Aligning and adjusting X-axis 2
Checking height offset
1. Place inspection bases
3
onto the two guide rails
1
and
6
in the area of the opposing adjusting
kits
2
(
è
Fig. 4.11).
2. Make sure the inspection bases lie correctly on the guide rails.
3. Place the steel straightedge
5
onto the two inspection bases.
4. Use a precision spirit level
4
to check the guide rail of X-axis 2
6
in the area of the adjusting kit for
an offset in height in relation to the already aligned guide rail of X-axis 1
1
.
è
Setpoint value: 0.1 mm/m (
è
A.2 Evenness)
1 3
4
5
6
2
3
Fig. 4.11