Controller
EXCM-2ST-C3-1
Festo AG & Co. KG
Postfach
73726 Esslingen
Germany
+49 711 347-0
www.festo.com
Assembly instructions
8063221
1606
[8063222]
Original: de
Controller EXCM-2ST-C3-1
English
. . . . . . . . . . . . . . . .
1
Intended use
The product is intended exclusively for control of the
two-dimensional gantries EXCM-10/-30-...-SB/-ST.
2
Safety instructions
Note
Before working on the product, switch off the
power supply and secure it against being switched
on again.
Observe the safety instructions in the applicable
documents.
2.1 Applicable documents
The following documents and media are additionally
available:
All available documents for the product
è
www.festo.com/sp
Designation
Content
Description
EXCM-10/-30:
Mechanical installation
Information on mounting, installation,
maintenance and dismounting of the
product
Description
EXCM-10/-30-...-E:
Commissioning
Information on commissioning of the
product with the two-dimensional
gantry EXCM-10/-30
Fig. 1
3
Mounting
3.1 Wall mounting
2
104
34
1
2
Fig. 2
Note
Observe maximum screw-in depth of 6 mm at the
mounting slots.
Tightening torque: 0.8 Nm ± 20 %
The controller
1
can be fastened with the two supplied
M4 screws through the mounting slots
2
.
3.2 H-rail mounting
1
2
3
Fig. 3
1. Fasten H-rail mounting (CAFM-D3-H)
2
with the in
cluded screws
3
to the controller
1
. Tightening
torque: 0.8 Nm ± 20 %.
2. Hang the controller over the hook of the H-rail clip
and into the H-rail from above.
3. Press from below against the H-rail until the controller
clicks into place.
