Festo EGSC-BS-KF, Инструкции и эксплуатация

Страница: 15 / 18

12 Fault clearance
Malfunction Possible cause Remedy
Coupling spacing is wrong. Observe the permissible coup-
ling spacings
è
Assembly
instructions of the motor
mounting kit.
Install the mini slide so it is free
of tension; maintain evenness
of the bearing surface
è
7.1 Preparation.
Change arrangement of the
tool/payload.
Tensions
Align the mini slide precisely
parallel to the second mini
slide.
Resonance point of the actuator
Rotational speed exceeded
Change the travel speed.
Controller is set incorrectly. Change parameters.
Squealing noises or vibrations
and/or the mini slide runs
roughly.
Guide is defective or worn. Exchange the mini slide.
Coupling spins. Check the assembly of the
motor mounting set
è
Assembly instructions of the
motor mounting kit.
Loads too high. Reduce load mass/torques.
Slide does not move.
Retaining screws on tool are too
long. Observe the maximum screw-in
depth
è
7.3 Attachment.
The reversing backlash is too
large
è
9 Service.
The idling torque increases.
Wear Exchange the mini slide.
Slide travels over end position. Proximity sensor does not
switch. Check proximity sensor, connec-
tions and controller.
Tab. 6
Fault clearance
15 Festo — EGSC-BS-KF — 2018-11c