Festo DG..-...-GA Series, Руководство по эксплуатации

Страница: 12 / 40

DGxx-...-GA
Festo DGxx-...-GA 0102NH English
12
Refitting the cover section
S
Refit the cover section as follows:
– Push in the cover section
– Tighten the fastening screws
– Fit the brush wiper.
– (Tightening torques see Fig. 9)
Using shock absorbers directly in the end
caps
6
:
S
Use only the kit specified in the section
“Accessories”.
Only this kit contains the screw elements which will enable you to fit the shock
absorbers correctly.
5 Commissioning
Please note
Protected guides which are already fitted at the factory do not require any
further treatment.
S
Do not carry out any modifications to the settings of screws and adjusting
parts if this is not explicitly specified in these operating instructions.
S
Remove the cover devices on the intended
slide surface as follows:
– Remove the brush wiper
– Push out the cover rail
– Fit the brushes
– Lift out the cover caps
(only if further holes must be used)
Fig. 8
Fig. 9
0,6 Nm
4 Nm
4 Nm