Festo CPX-FB32, Электронное руководство

Страница: 21 / 136

1. Installation
1−5
Festo P.BE−CPX−FB32−EN en 0605NH
Dismantling and fitting
The field bus node is fitted in a manifold base of the CPX
terminal (see Fig.1/2).
Dismantling Dismantle the field bus node as follows:
1. Loosen the 4 screws in the field bus node with a Torx
screwdriver size T10.
2. Pull the field bus node carefully and without tilting away
from the contact rails of the manifold base.
1
Field bus node
CPX−FB32
2
Manifold base
with contact rails
3
Torx T10 screws
3
1
2
Fig.1/2: Dismantling/fitting the field bus node
Fitting Fit the field bus node as follows:
1. Place the field bus node in the manifold base. Make sure
that the grooves with the power contact terminals on the
bottom of the field bus node lie above the contact rails.
2. Push the field bus node carefully and without tilting as far
as possible into the manifold base.
3. Tighten the screws at first only by hand. Place the screws
so that the self−cutting threads can be used.
4. Tighten the screws with a Torx screwdriver size T10 with
torque 0.9 ... 1.1 Nm.