Ferrofish Verto 32, Руководство пользователя

Страница: 10 / 16

10
08. Troubleshooting
Error Possible cause Troubleshooting
POWER LED does not light Power supply not plugged in or
defective Check the power supply
The device is switched off Switch on the device with the
power button. Seriously.
POWER LED flashes quickly Power button pressed The power LED flashes quick-
ly when the power button is
pressed on a switched-on de-
vice.
POWER LED flashes slowly The Verto unit is booting in the
start-up process Wait approx. 20 seconds for the
boot-up-sequence to finish.
DANTE LED does not light up
(see Power LED) Mains cable defective or the
wrong type (crossed) is used Use a different network cable
Verto is booting Wait approximately 20s until the
boot process is finished
Error in the DANTE network Check the functioning of the
DANTE network.
DANTE LED is flashing No connection to the Dante
network Check the functioning of the
DANTE network.
Device is „slave“, but no “Mas-
ter“ was found on the DANTE
network. Set a device in the DANTE net-
work to „Master“
Sample rate on the network
has been changed When changing the sample rate,
the outputs are muted briefly.
MADI coaxial LED lights low Both ports (opto & coax) re-
ceive valid signal
Both signals are valid, but the
optical port is automatically used
for DANTE.
This is a status indication, not
an error.
ADAT Input LED flashes A sync process has failed Set all connected ADAT devices
to „Slave“.
ADAT Input LED is lit constantly,
regularly interrupted by flick-
ering Both devices are „Master“. Set all connected ADAT devices
to „Slave“.