Ferris IS700Z series, Руководство по настройке и регулировке дилера

Страница: 13 / 16

Not for
Reproduction
13
28
To set the cutting height at 1-1/2” (3,37 cm):
1. While sitting in the operator’s seat, press the deck lift
foot pedal (C) forward until it locks into the 5" (12,7 cm)
position.
2. Remove the cutting height adjustment pin from the hole
that it is installed in.
3. Press the deck lift foot pedal forward and then push the
lock lever (D) towards the right to release the lock.
4. Slowly release the deck lift foot pedal until it comes to
rest against the stationary pin (E) in the 1-1/2” (3,37 cm)
cutting height hole.
5. Place the cutting height adjustment pin in the storage
hole (F).
To set the cutting height in the range of 1-3/4” (4,40 cm)
and 4-3/4” (12,06 cm):
1. While sitting in the operator’s seat, press the deck lift foot
pedal forward until it locks into the 5" (12,7 cm) position.
2. Place the cutting height adjustment pin in the desired
cutting height.
3. Press the deck lift pedal forward and then push the lock
lever towards the right to release the lock.
4. Slowly release the deck lift foot pedal until it comes to rest
against the cutting height adjustment pin.
To set the cutting height at 5" (12,7 cm):
1. While sitting in the operator’s seat, press the deck lift foot
pedal forward until it locks into the 5" (12,7 cm) position.
2. Place the cutting height adjustment pin in any open
cutting height hole. The lift lock lever holds the mower
deck at 5" (12,7 cm) while cutting.
Neutral Adjustment
The neutral system for this mower consists of two neutral
linkage rods and a pivot that connects the ground speed
control lever to the transmission. The lower rod that connects
the transmission to the pivot is factory preset and should not
be changed for neutral adjustment purposes. The adjustment
is achieved by changing the length of the upper rod (A,
Figure 29) that connects the ground speed control lever to the
pivot.
29
Determining if Adjustment is Necessary: If the zero-turn
rider "creeps" while the ground speed control levers are
locked in the NEUTRAL LOCKOUT position, then it may be
necessary to adjust the linkage rods.
Note: Perform this adjustment on a hard, level surface such
as a concrete floor.
1. Disengage the PTO, engage the parking brake and turn
off the engine.
2. There are two nuts (B) on the linkage rod. Loosen the
nuts from the ball joints (C) and turn the linkage rod to
adjust.
• If the machine creeps forward, turn the
rod clockwise (while standing at the rear of the
machine, facing forward);
• If the machine creeps backward, turn the
rod counter-clockwise (while standing at the rear of
the machine, facing forward).
3. Lock the jam nut against the ball joints when neutral is
achieved.
Note: This adjustment should not be performed while the
machine is running. It may take several attempts to achieve
neutral, depending on how much the machine creeps.
Return-to-Neutral Adjustment
Prior to performing this procedure the Neutral Adjustment
Procedure must be completed.
WARNING
To avoid serious injury, perform adjustments only with
engine stopped, key removed, and tractor parked on level
ground.
1. Position the ground speed control levers into the
NEUTRAL LOCKOUT position