Ferris IS2100KOH2761, Руководство оператора, Страница: 20 / 44

Not for
Reproduction
clippings which decompose properly (much more quickly than
longer clippings). The ideal cutting height will vary with climate,
time of year, and quality of your lawn. We recommend that you
experiment with both the cutting height and ground speed until
you achieve the best cut. Start with a high cutting height and
using progressively lower settings until you find a cutting height
that is matched to your mowing conditions and preferences.
Pushing the Rider by Hand
NOTICE Do not tow rider.
Towing the unit will cause transmission damage. Do not use
another vehicle to push or pull this unit.
1. Disengage the PTO, engage the parking brake, turn the
ignition OFF, and remove the key.
2. Locate the transmission release levers (A, Figure 18)
underneath the engine deck of the machine between the
two rear wheels on the transmission cradle (B). There is
one transmission release lever on each transmission. The
transmission release levers open and close the transmission
bypass valves.
18
3. To open the transmission bypass valve (bypass position)
(C), move the transmission release lever up and pull it
towards the rear of the machine. When the second nut (D)
has passed through the hole, lower the rod down into the
slot so it will stay in the bypass position. Repeat the process
for the other side of the unit.
4. Disengage the parking brake. The rider can now be pushed
by hand.
5. After moving the unit, close the bypass valve (run position)
(E) by raising the transmission release lever so that the
back nut clears the slot, push the lever towards the front of
the machine. Repeat the process for the other side of the
unit.
Note: Both transmission release levers must be in the same
position.
Raise and Lower the Roll Bar
WARNING
Avoid serious injury or death from roll over:
• Keep roll bar in the raised position and use seat belt.
• There is no roll over protection when the roll bar is down.
• Lower the rollbar only when necessary and NEVER
remove it.
• Do NOT use seat belt when the roll bar is down.
• Raise the roll bar as soon as clearance permits.
• Do NOT jump off if mower tips.
To lower the roll bar:
1. Pull the hair pin clips (A, Figure 19) out of the retainer pins
(B).
19
2. Push or pull the top of the roll bar (C) forward against the
spring clips (D) and remove the retainer pins (B).
3. Lower the roll bar and reinstall the retainer pins and hair
pin clips to secure the roll bar in the down position (see
insert, Figure 19).
To raise the roll bar:
1. Pull the hair pin clips (A) out of the retainer pins (B) and
remove the retainer pins.
2. Raise the roll bar (C) until the top of the roll bar (C) contacts
the spring clips (D) on the upright tubes.
3. Push or pull the top of the roll bar forward against the spring
clips and reinstall the retainer pins and hair pin clips to
secure the roll bar in the raised position.
20 ferrismowers.com