Ferris 5901850, Руководство оператора

Страница: 30 / 40

Not for
Reproduction
30 ferrismowers.com
38
To Adjust the Handle Placement
Loosen the jam nuts and adjust the placement bolt (B) in or
out to properly adjust the lever end spacing.
To Adjust the Handle Height
Remove the mounting hardware and reposition the handle
either up or down from its original position. You will need to
adjust the handle alignment again as described above.
Cutting Height Adjustment
The cutting height adjustment pin (A, Figure 39) controls
the cutting height of the mower deck. The cutting height
is adjustable between 1-1/2" (3,8 cm) and 6" (15,2 cm) in
1/4" (0,64 cm) increments.
Note: Make sure that the pin is inserted into the holes in both
upper and lower plates of the pin box (B).
39
1. While sitting in the operator's seat, press the deck lift
pedal (C) forward to raise the mower deck until it locks
into the 6" (15,2 cm) position. Do not hold the pedal down
after the mower deck locks into the 6" (15,2 cm) position.
WARNING
Pinch Point Hazard
When pressing the deck lift pedal (A), keep your foot (B) on
the pedal to avoid a potential pinching hazard as the deck
height link (C) moves forward.
2. Place the cutting height adjustment pin in the desired
cutting height.
Note: If cutting at the 6" (15,2 cm) cutting height, place the
cutting height adjustment pin in the pin storage hole (D).
3. Press the deck lift pedal forward to raise the deck and
release the deck lock (E).
4. Push the deck lift lock lever to the right to release the
lock.
5. Gravity will lower the mower deck until the deck lift pedal
comes to rest against the cutting height adjustment pin.
Deck Lift Lock Lever Lockout Plate
Operation
The Deck Lift Lock Lever Lockout Plate (A, Figure 40) can be
used to prevent the mower deck from locking the deck in the
TRANSPORT position if you raise deck during operation to
clear an object.
1. Move the deck lift lock lever (A) away from the operating
position, and rotate the deck lift lever lockout plate (B) to
the UNLOCK (C) position (facing towards the operating
position) and allow the deck lift lever lockout plate to
contact the deck height box.