Not for
Reproduction
Change Engine Coolant
See engine owner's manual for specific engine coolant
procedures. The drain valve is located at the base of the
right-hand side of the radiator.
Clean Radiator, Screen & Oil Cooler
Clean the radiator, screen (B, Figure 25) and oil cooler fins (C)
before each use, or as required (depending on conditions) to
allow proper air-flow through radiator and hydraulic oil cooler.
1.
Raise the seat plate.
2.
Lift the radiator screen straight up to remove the screen.
Flush the screen with water or blow clean with air. Flush
the radiator core with water or blow clean with air. See
engine owners manual for proper radiator cleaning
procedures.
3.
Clean all dirt, grass, and debris from the oil cooler fins.
4.
Reinstall the radiator screen. Make sure the screen is fully
seated in the carrier.
5.
Lower the seat plate.
Checking Tire Pressures
Tire pressure should be checked periodically, and maintained
at the levels shown in the Specifications chart. Note that these
pressures may differ slightly from the "Max Inflation" stamped
on the side-wall of the tires. The pressures shown provide proper
traction and extend tire life.
Seat Adjustment
The seat can be adjusted forward and back. Move the lever (A,
Figure 26) towards the left, position the seat as desired, and
release the lever to lock the seat into position.
26
Ground Speed Control Lever Adjustment
The control levers can be adjusted in three ways. The alignment
of the control levers, the placement of the levers (how close the
ends are to one another) and the height of the levers can be
adjusted.
To Adjust the Handle Alignment
Loosen the mount bolts (A, Figure 27) and pivot the lever(s) (C)
to align with each other.
27
To Adjust the Handle Placement
Loosen the jam nuts and adjust the placement bolt (B) in or out
to properly adjust the lever end spacing.
To Adjust the Handle Height
Remove the mounting hardware and reposition the handle either
up or down from its original position. You will need to readjust
the handle alignment as described above.
Mowing Height Adjustment
The cutting height adjustment pin (A, Figure 28) controls the
mower cutting height. The cutting height is adjustable between
1-1/2” (3,8 cm) and 6” (15,2 cm) in 1/4” (0,64 cm) increments.
24
Содержание 5100/61RDCE
Страница 1: ...N o t f o r R e p r o d u c t i o n...
Страница 30: ...N o t f o r R e p r o d u c t i o n Notes...
Страница 31: ...N o t f o r R e p r o d u c t i o n Notes...
Страница 32: ...N o t f o r R e p r o d u c t i o n...
